Armour and Shields

Armour

Armour is skin of the fleet, and it is by this skin that the fleet survives.

Armour costs the same per strength point at the first rating (thickness) as it does at the last.

However, it takes more armour to cover the ship the thicker the armour is since the ship is becoming larger with each added layer.

This can be helped quite a bit by Armour tech increases.

But, Armour has positive and negative sides.

Positive

Armour has a great strength per ton ratio compared to other ship components.

A ship with more armour rating can take much (deeper) hits from lasers and still have its internals intact.

Negative

Armour slows a ship down with its weight.

Armour adds to the breakdown chance of a ship.

Armour takes maintenance supplies to repair.

Overrall look at Armour

Now Armours main issue is it slows down your ship, but large heavily armored ships aren't meant to chase down the enemy and beat them, they are to meet the enemy's attack front on and beat them off while surviving the battle.

Armour on smaller ships is where this issue lies. Small ships under 10,000 tons require minimal Armour to reach high speeds.

These ships can also be considered of negligible risk to use as well so it is fine to armour them lightly for the possibility to close with

the enemy and unload their lethal cargo all the sooner. But they need to actually close with the enemy without dying which bring about the age old problem Armour, Speed, Firepower, Pick 2.

Ok so here we are.

I have Armour rating 13 on my ship now, that is a total weight of 4585 tons. providing a total of 1100.4 Armour strength

If i did that Tonnage amount in (3 strength 300 recharge shield) I would have only 276 shield strength!

92 shields x 50 weight each = 4600 tons, and the cost is actually just slightly cheaper than armor at that weight amount, 100 less cost.

but those 92 shields will regenerate 1 shield strength each every 100 seconds. (total recharge time is 300 seconds for a 3 strength shield)

so that is 92 damage you wont be taking against normal weapons every 100 seconds.

BUT 276 total shield strength is... very anemic. that is only 50x6 strength missiles to blast right through! That is just 1 salvo from some NPR's! If you were relying on this alone against NPR's your ships would be fodder.

the break even point for shields in time, would be around a 800 second battle with very slow enemy attacks allowing you to recharge your shields. This almost never happens though so entirely useless.

Shields

Shields are the buffer between the armor and the incoming weapons fire.

Shields have a few positives and negatives as well.

Positives

Regenerate at variable speed depending on technology researched.

While they are up and running, require no maintenance to repair as they take damage.

Negatives

Strength per ton is much worse than armor at every point.

Nearly same cost as armour for worse protection.

General Shield Info

For weight they arent worth it at all when alone, and other than for ships that are large and meant for decade long voyages through enemy space you should think carefully about your approach to using them en mass.

shield strength tech goes from 1-15 per shield generator and recharge.

By lvl 5 strength you begin generating a noteworthy amount of protection along with recharge.

5x20 = 100 shield strength for 1000 tons

By lvl 10 strength you have a fairly decent protective field around the ship per generator. Take into account that with lvl 10 shield recharge you would have

10x20 = 200 shield strength at 1000 tons. That is the point where you can start exchanging shields for armor and easily shields would do better than armor due to regeneration technology as long as the enemies salvo's of missiles werent all bunched into a single giant strike.

each shield generator regenerates 3.3 damage per second, with 20 shield generators thats 66 dmg every 100 seconds. not too bad for only 1000 tons of shields. every 100 seconds you could be absorbing plenty of extra damage.

This also protects you from minor conflicts forcing you to use up maintenance supplies repairing the Armour on the hull.

Combining Armour and Shields

A effective ship should have a mix of Armour and Shields.

Armour is always more cost effective at all levels than shields for just plain Strength.

However no damage leaks through shields except from Meson's and Microwaves.

You can create a damage reducing shield barrier that constantly recharges and reduces the damage done and thereby the Depth of damage done by lasers.

so if you have 20 shields x 5 strength with recharge rate 300 seconds, every 100 seconds you could bring your shields back up to 1/3rd strength and reduce incoming laser and missile strikes on the armor by that much.

This only gets better with higher shield technology and can provide quite a buffer for the Armor Rating. Allowing a player to lighten his ships for increased speed or more firepower in a weight range.